52T Steel Spur (1.0M)
Review: 5 - "A masterpiece of literature" by , written on May 4, 2006
I really enjoyed this book. It captures the essential challenge people face as they try make sense of their lives and grow to adulthood.
Categories
Kits

52T Steel Spur (1.0M)

Available: In Stock
$29.88
Image
  • Order within

52t Mod 1 Steel Spur Gear E Revo 2 X-Maxx XO-1

ERVT52M01

Hot Racing 52 tooth hardened steel Modulus 1 (1.0 metric pitch) spur gear for the Traxxas E Revo2, X-Maxx 6S and 8S, and XO-1.

FEATURES:

- CNC machined hardened steel construction
- Black oxide finished
- Laser etched tooth count marking

YOU WILL RECEIVE:

- One (1) 52 tooth, 1.0 modulus steel spur gear

REQUIREMENTS:

- Do NOT use the pin system for setting the X-Maxx gear mesh. Instead, manually set the gear mesh without the pins. Refer to the Traxxas manual for instructions (ref. pg.22 - Adjusting Gear Mesh):
- With the pins removed, use the four 4x16mm button-head cap screws on the bottom to set gear mesh. Loosen the four 4x16mm button-head cap screws. Cut a narrow strip of notebook paper and run it into the gear mesh. Slide the motor and pinion gear into the spur gear. Tighten the four 4x16mm buttonhead cap screws, and then remove the strip of paper. You should be able to run a fresh strip of paper through the gears without binding them.

SPECIFICATIONS:

- Overall diameter: 54mm
- Gear face width: 8mm

52t Mod 1 Steel Spur Gear E Revo 2 X-Maxx XO-1

ERVT52M01

Hot Racing 52 tooth hardened steel Modulus 1 (1.0 metric pitch) spur gear for the Traxxas E Revo2, X-Maxx 6S and 8S, and XO-1.

FEATURES:

- CNC machined hardened steel construction
- Black oxide finished
- Laser etched tooth count marking

YOU WILL RECEIVE:

- One (1) 52 tooth, 1.0 modulus steel spur gear

REQUIREMENTS:

- Do NOT use the pin system for setting the X-Maxx gear mesh. Instead, manually set the gear mesh without the pins. Refer to the Traxxas manual for instructions (ref. pg.22 - Adjusting Gear Mesh):
- With the pins removed, use the four 4x16mm button-head cap screws on the bottom to set gear mesh. Loosen the four 4x16mm button-head cap screws. Cut a narrow strip of notebook paper and run it into the gear mesh. Slide the motor and pinion gear into the spur gear. Tighten the four 4x16mm buttonhead cap screws, and then remove the strip of paper. You should be able to run a fresh strip of paper through the gears without binding them.

SPECIFICATIONS:

- Overall diameter: 54mm
- Gear face width: 8mm